Axxess ASWC
 

Another one of those threads where ASWC-1 doesn't seem to work :(

I have read through all the threads I could find including the one sticky above.

I have 2010 with BOSE and non-Nav. I did not do the bluetooth wire in the trunk, the wires were not the same as DIY so I skipped that(This is now completed as well).

A question and a couple of issues:

• Do you re-install stock amp behind HU after upgrade? (What I was thinking of end up being the HVAC control module so that had to go back in of course)

• During Bluetooth call, there is no sound coming from speakers, Microphone seems to work. Bluetooth steaming works fine.(Fixed... had the 4 wires incorrectly plugged in at the back of HU)

• ASWC-1 sees both wires connected through green LED Blink test(red/grey and blue/grey). During initial boot auto program changes volume. Once HU is detected with 6 red blinks, it goes to RED-GREEN cycle. No button works.
  (Fixed...It doesn't matter if ASWC sees connections if it is connected to wrong wire on the other side. According to nissan service manual I had wires all wrong)

I created this for BOSE owners without Navigation. Year model 2009-2011. It is for Audio Control module in the trunk next to amp. Follow this DIY: http://www.the370z.com/diy-section-d...rol-phone.html


http://i35.photobucket.com/albums/d1...pssocvgrdm.png
http://i35.photobucket.com/albums/d1...ps5xvjwf14.png

This is how it looks like.



Edit: This was caused by connecting to incorrect cables based on Metra/AXXESS Instructions.

Updating Firmware from 4.06 to 4.07... Wish me luck guys!! hope they fix their screw up

edit: nope... it fails to auto program and fails to enter manual program mode too

Ok some progress... Wiring in Nissan service manual is what I should have followed. http://images.tapatalk-cdn.com/15/09...1aa9b94046.jpg

Alright, i'm gonna close this thread. All buttons work! I will check with service manual for my specific year before starting any future electrical DIYs.