Sadly, my factory dash speakers must go under the knife.

http://images.tapatalk-cdn.com/15/09...a7533094b1.jpg

CDT's fit right in there.

http://images.tapatalk-cdn.com/15/09...42a29ff8f2.jpg

Note on the Azzess SWC-1

Their grey/blue wire to our pink
Their grey/red wire to our blue

Self programmed like a charm.

http://images.tapatalk-cdn.com/15/09...52e92ed359.jpg

Wire management.

http://images.tapatalk-cdn.com/15/09...9bae3b0041.jpg

Looks like everything is powering up. I'm digging the Kenwood.

http://images.tapatalk-cdn.com/15/09...28ab416c30.jpg

Looks like a car again.

http://images.tapatalk-cdn.com/15/09...3ec8153f8b.jpg

Doors are done.

http://images.tapatalk-cdn.com/15/09...497176f775.jpg

Done for today. All that's left is to hook up everything in the hatch and start tweaking.

Seems to be a decent color match.

http://images.tapatalk-cdn.com/15/09...442ee12201.jpg

When you installed the head unit, did you use the factory mount?

Sent from my Nexus 7 using Tapatalk

No, it wouldn't work. I used the Metra 99-7607B kit. The radio was a bit of a booger getting in the kit, but I finally beat it into submission. It looks good in there.

Well, now you've got me nervous. I have everything ready to do my own HU install this weekend...except a dash kit.

After reading this thread:
http://www.the370z.com/audio-video/7...ailable-3.html

I didn't think I'd need one, and could just reuse the factory one. But your experience says otherwise, so now I'm not so sure.

I tried to use the factory bracket at first, but there were no matching bolt holes in my radio.

I am reusing the factory one with my pioneer and it it worked out OK. There is a small gap around the radio though.