Help getting sub wireing to rear hatch area

frankiev

Can someone advise on how to get the wiring for my subwoofer from the pass seat to the rear hatch area .Also ,I want to replace the factory speakers (non bose ) .How are you guys running the tweeter wires to the a pillar
Thanks

RonRizz

pull out bottom section of parcel shelf (carpeted piece) lift carpet along door sill, and run wire fish from parcel shelf down to door sill. to a pillars, remove dash grill and tweeter, drop wire fish down through hole to floor.
Easy Peasy

__________________
P99rs Head Unit--- Amps- 2 Pioneer Prs800d --- Zapco ST1000MX---Zapco ST-4XSQ---- SI BM mk5 Subs---SI TM65v2 Midbass--- SI M3 mids--- SI M25 xbl2 tweeters ----- 2016 MECA street class 3rd place at world finals

frankiev

Thanks So if I understand I can put the crossover somewhere under the dash and feed the tweeters from there . Do you know what color the 6 1/2 speaker wires are where they come thru the lower dash .

370zHawaii

green and brown come to mind I can't remember both sides, easiest way is when you take the door off you will see which wire is which. I put my crossovers right by the fuse panel on one side and on the complete opposite side inside that plastic panel on the passenger side using 3m doubled sided tape, hold well no drilling required. Very easy to conceal.

What I did was use the existing speaker wire inputs from harness to crossover, then ran new wire fromt the crossover up into where the speakers are located. It will take patience to do the doors if you want it to be clean. There is a DIY Door speaker wire DIY on how to run the door wires. I used the panel puller flat edge plastic to push the new tweeter wire inside the dash.

Depending on your radio stock/aftermarket you will have RCA outs for a sub or stock you will have to tap into one of the existing outputs. I ran mines straight to the back under the center console and to the amp using RCA.

Also would help if you could give a little more info on your setup, I am going off my setup and yours could be completely different.

Sidenote: have a 9 volt battery handy so you can test the polarity of the wires leading into the speakers in case you forget which wire is positive and negative, I tripled check each one because well OCD.

Good luck and congrat on swapping out the speakers.

frankiev

Thanks for thei nfo. I have a pioneer Hu w/touch screen and an ADS PQ10 for the front speakers w an older MTX for the 10in infinity kappa 10.1 sub .Im using a Nakamichi EC200 for the crossover

Im probably going to change the MTX to a Harmen Kardon TC300