if anyone takes one of these solenoids out of the, please check to see if there is any lubricant at all on the pin or opening. Condensation on metal that then freezes can be one possible scenario for the sticking pin. also, the programming on the BCM needs to be checked to make sure this voltage to disengage the pin does not stay applied until a feedback signal. There is no reason this solenoid needs more than 2 seconds of being energized to do the job. anymore, and the life expectancy is going to be diminished. has anyone experienced this twice?
If one wire becomes shorted to power or ground, this could cause the solenoid to prematurely die. I wonder if there is possibly a harness problem?
__________________
Get some roosters for eggs and Bulls for milk . Then you will see that gender matters. Especially at milking time.
|