Trailer Ramp Adapter for RLL-87-2 Race Ramps
The design for an optional Trailer Ramp Adapter for the 14" wide RLL-87-2 Race Ramps was approved this week. We should have this product available before the end of February. Basically the adapter converts the incline section of the RLL-87-2 ramp into a trailer ramp. The price of the RLL-87-2 plus the adapter is less than the combined price for a set of RR-XT-2 service ramps and the RR-TR-8 trailer ramps. The 6.8 degree initial angle of approach on the RLL-87-2 ramps is considerably less than the standard products (10.75 degrees for the RR-XT-2 and 8.4 degrees for the RR-TR-8).
The attached drawing shows the incline section of the RLL-87-2 ramps and the adapter. A similar adapter will not be made available for the RLL-72-2 ramps since the 72 inch ramps are only 12" wide. Brute Industries considers 14" the minimum width for trailer ramps.
As with the "step" on all Race Ramps trailer ramps, the top of the adapter is reinforced to support the combined weight of your car and the trailer door (or trailer ramps). The price of the RLL-87-2-TA adapters is $95/pair including shipping to any destination in the 48 Continental States.
Last edited by Fred@ReverseLogic; 02-03-2011 at 10:47 PM.
|