View Single Post
Old 12-08-2010, 08:28 AM   #47 (permalink)
flashburn
A True Z Fanatic
 
flashburn's Avatar
 
Join Date: May 2009
Location: Central Florida
Posts: 1,884
Drives: '12 Corvette GS 6M
Rep Power: 19
flashburn is just really niceflashburn is just really niceflashburn is just really niceflashburn is just really niceflashburn is just really nice
Default

So I'm going to be doing this today, but I just had a question.

If I do it one pad at a time, do I just do the following:
1. Remove pins.
2. Push/Pull one of the pads towards the pistons.
3. Remove that pad.
4. Apply brake grease between shim and pad.
5. Slide in new pad.

Only reason I'm a bit confused is the DIY link included shows them pulling out each pad, and then putting them back in sideways? Is that necessary, or can you just remove them and then put in the new pad?
__________________
Current Ride: 2012 Chevrolet Corvette Grand Sport Centennial Edition Carbon Flash 6M
Previous Ride: 2009 Nissan 370Z Sport Platinum Graphite 7AT
flashburn is offline   Reply With Quote