Quote:
Originally Posted by daisuke149
if your picture is about the part that is not fitting
thats not an issue
just gotta hold it up while you slike the other ppipe through
when you use the hangaers it will be between those two. shouldnt rattle. at all times that you tighten the bolts in each section, hold the part slightly up to keep it as "straight" as possible while tightening it.
|
We tried sliding that pipe piece, but did not work unless the metal plate was either cut or removed. I bought the CBE with welds already done to stop any leaks. I'm not sure if that made a difference. For now, I removed the plate but I'm probably going to have to cut the center piece to make room for the pipe and still have my gas tank with some protection. FML, other than that the CBE sounds F**ing awesome!!