I had this relo done by a shop here in Phoenix, AZ... didn't do it myself, but I'll try to capture some of the details to help those that DIY
Materials:
Steps (roughly):
- Remove old battery
- Remove old negative cable
- Connect 12ft line to starter teminal
- Re-use red plastic cover
- Run 12ft line through point as shown in pic below
- Run line along passenger side under carpet
- Run line into rear compartment... you will have to decide where to mount... mine pictured below
- Install battery with hold down
- Connect battery leads
- Grind a spot on the chassis, to reveal bare metal
- Drill a hole or use existing hole and enlarge, suitable for fastening negative terminal... connect terminal
I realize I'm not going into much detail but just wanted to get the thread started... others can fill in the blanks... good luck
Pics: