Just a heads up. ClearMask is VentureShield film. I used to install their film and know the owner Jim very well. They are pretty good guys down there but I have been just buying ventureShield Ultra straight out as opposed to going through them. Looks like you did a good job on your install. I can tell from looking that you used a little too much soap in your slip solution... the water should still be clear. Also to seal your edges down the best way to do it is by using a heat gun... or a hair dryer will work also. Simply pressing the edges down while the car is warm is not hot enough to properly seal them. I can tell you that if you dont heat it with a hairdryer that within 6 months the edges will be lifting and you will have a very visible dirt line under the film. White is a must for heat sealing... trust me on this. So before you go much longer take the car in and heat the edges then press them down with a hard card. That will save you in the long run.
By the way I was in the Air Force 15 years and got out two years ago to do clear braas full time. I was a 1C6 while I was in. Always good to see another Air Force member on the forums. If you ever have any questions about your clear bra please let me know. I will be happy to help you out.
Thom
|