Hey guys....I can't quite seem to get this to work. When all I can think is that I have the wrong wires hooked up to the resistor. When I try to program the buttons the first button with turn of the red light.... but when i let go of the button it does not come back on.... From the factory harness I have the 47 ohm resistor going to the purple wire pin 6 and the 150 ohm resistor going to the blue wire pin 16 and both resistors going to the white wire. I cut the one loop and insulated both ends with electrical tap and have grounded the black wire and connected the red one with the other red wires. I have also connected the blue and yellow wire with the one to the unit.
Are you suppose to unplug the harness from the unit when you program the buttons? Any suggestions would be appreciated very much. The only other thing i can think of is that i didn't actually get a 150 ohm resistor but i'm quite certain it is.
Last edited by david712370; 05-13-2009 at 09:10 AM.
|