View Single Post
Old 09-13-2010, 08:59 PM   #653 (permalink)
Cmike2780
A True Z Fanatic
 
Cmike2780's Avatar
 
Join Date: Jun 2010
Location: Long Island
Posts: 5,059
Drives: slowwww
Rep Power: 29
Cmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond reputeCmike2780 has a reputation beyond repute
Default

Quote:
Originally Posted by atx370z View Post
NO... dont remove the bumper. There are some areas where you have to put a little bit of force on the peices while you drive the screw in to get it to fit just right. It's MUCH easier with the bumper on. All i did was jack the front up and put it on jack stands so i had enough room to lay down and get a drill underneath.

One thing i know for sure that has been debatable in this thread... is if you install the sides without the center, it will look funky.
Thanks for the info. I test fitted without the center piece & it doesn't look right at all. The side pieces stick out too much, especially if your looking down. The sides look a lot bigger in person.
__________________
[09][MB][6-Spd MT][Touring][Stillen Gen III][K&N][Borla CBE][Evo-R]

Cmike2780 is offline   Reply With Quote