DIGItonium

The automatic Z I test drove over a year ago did not have this issue, and the temps were cooler at the time it was being tested. It was the first time testing a 370Z, and my initial impression was that it was eager to rev to past 3k with little throttle tip in. I was sold and ordered the 6MT.

What I would like to see done since I don't have the funds to get the appropriate tools, is to get a data acquisition board of some sort to record the voltages for the gas pedal, ECU outputs, VVEL outputs, stepper motor inputs, and temperatures in different areas including the stepper motor assembly. All of this data would be logged and graphed to observe temperature and the relationship of the signals controlling throttle response.

The gas pedal voltage should be 100% linear from 0-5V.
The ECU throttle output may not have a 1:1 correlation to the gas pedal potentiometer.
The VVEL controller, which I know nothing about, I will assume is a black box with input and output to control the stepper motor.

Somewhere along the lines of capturing this data and graphing it we should see somewhere in the system of gas pedal travel (2nd gear, pressing pedal from position 0 to max) we should be able to graph the delays and compare it to temperature. Obviously something's getting hot and slow. Has anyone felt the stepper motors? That thing is scorching hot. I'd be curious to know where the VVEL "box" is located as well.

[EDIT] Service manual indicates there are terminals for the VVEL Control Shaft Position sensor, so the voltage levels can be measured here. Then there's the VVEL Actuator motor which we can probably log and compare with the sensor values. Just for kicks, we can log the TPS sensor as well.

__________________