09-10-2010, 04:53 PM
|
#20 (permalink)
|
|
Base Member
Join Date: Apr 2009
Location: Texas
Posts: 135
Drives: 1959 Triumph TR3A
Rep Power: 16
|
Finally got around to installing my Relentless Autosports two piece floating front rotors and the custom valved BC ER coilovers with Swift springs. I will working on the rear shortly, but I did notice Zat_Zuma has installed his rear RA two piece rotors mentioned a another thread.
I used exisiting DIY's from this forum and the Nissan service manual to assist in the install. I don't think anything needs to be added except use the right tools and make sure your Z is properly and safely supported when working on the suspension. Some of the torque requirements are up tp 120 ft/lbs and breaking some the bolts loose remind me dreaded HFC bolt - torqued by Nissan to some ridiculously high but not required value.
When I get the rears done I will go for a test drive and then replace the brake pads and install the SS brake lines.
The Stillen sways will be installed prior to the first test drive.
A few pictures:
|
|
|