from NAGTROC post:
Quote:
-Disconnect the negative terminal of the battery.
-Remove the front bumper
-Clean off any finger prints or oil from the surface before installation
-Install the DRL in a position where it will not interfere with the bumper fitment
-This system can be wired to the Ignition switch or the light switch (side marker)
-Reconnect the negative terminal of the battery and check that the DRL is functioning properly.
-When reinstalling the bumper, be careful to not scratch the DRL surface.
-The use of painters tape to protect from scratching is recommended during bumper installation.
|
...looks pretty straightforward.