ATTN: This decal design has been discontinued. Please click here for new decal design: NEW The370Z.com Decals Preview 04.19.09
Yes! The decals are here. I am sorry it took a little while to get them. I will be contacting premium members for their mailing address and mailing them out today. Also, sorry about crappy pictures. It would NOT stop raining over here
If you are NOT a premium member and still would like to get the decals, they are
$4 shipped to your door for a set of two. (pm me for details)
Since I am in a good mood, I am glad to announce that anyone buys
premium membership WITHOUT decals in the month of December will get a set of decals for FREE. This promotion will be active through the month of December only!
The decals are silver. I went with that color because it looks really good on the glass. The font is the famous "Got Milk!" font. (I know, I am a geek
). It's very easy to install them. You can basically put them ANYWHERE on the car as long as you wiped the area off really good with rubbing alcohol.
Here are the "Instructions" that came with the decals.
Quote:
Clean the surface very well with alcohol. The surface temperature must be between 55 and 75 degrees Fahrenheit during installation. A hair dryer is often used to warm the surface if necessary. Do not install in high heat or direct sunlight.
Measure and tape decal in position. Make a tape hinge with masking tape on one side of the decal. This will keep it in position during installation. Lift the decal and remove the backing which covers the adhesive. Begin to squeegee the decal down starting at your tape hinge side. Slowly lower it to the surface while using the squeegee. This is kind of like turning the page of a book. Allow only one section of the decal to touch at a time as you squeegee it down. Once completely down, squeegee entire decal to thoroughly set the adhesive. Then, remove the top decal carrier sheet slowly at a low angle to the surface. This will leave the decal installed. If you have any air bubbles, you can pierce them with a pin or they will deflate on their own like a balloon with time.
|
I taped the top of the decal to the glass and it worked out really well. You don't need squeeze. Just use a simple cloth.
This is a great way to support our forum. I will be very thankful if you rock our forum decal on your car
