Ok I just found the threads I was thinking about.
Limp mode thread 1
Limp mode thread 2
Apparently Stillen is working on one for the VQ37 thanks to the G37 guys. Should probably work for the 370Z too I assume?
"TORQUE CUT CONTROL (AT HIGH ENGINE OIL TEMPERATURE)
ECM receives engine oil temperature signal from engine oil temperature sensor.
To avoid VVEL performance, ECM performs the engine torque cut control at high engine oil temperature.
If engine oil temperature is too high, engine oil viscosity will change. As a result, engine oil pressure is
decreased. This control is to control the VVEL operating angle by operating the VVEL actuator sub assembly.
If this control is operated, engine performance will decrease, then maximum engine speed is reduced a little,
for example.
NOTE:
If the engine oil temperature sensor is deteriorated, its characteristic will change.
In this case, the operating temperature for engine torque cut control might be decrease.
Perform Component Inspection of the engine oil temperature sensor to check for the deterioration.
Refer to EC-248, "Component Inspection". "