Quote:
Originally Posted by shadow2k
How exactly did you do this?
|
i bought large washers and M10X50 1.25pitch screws (2pcs) to raise the back end of the seat. This is modshack's suggestion and it worked out great.
the front screws you just loosen a bit when you install the rear spacers and new bolts, and then tighten down. i think it was 36lbs/ft torque on all 4 bolts. check the service manual.
then you can use your seat adjustments to get the tilt of your seat bottom
to your preference. it turned out perfect for me.
thanks again, modshack!
