Nissan 370Z Forum - View Single Post

RedNismo · 05-03-2010, 03:59 AM

Hi All,
I just bought a low profile 2 ton jack from Harbor Freight so I could change my oil(my very 1st time). It turned out the low profile wasn't low enough for the Nismo front. So I had to use 2 stock jacks from different cars to jack each side up slightly to sneak in the 2 ton jack. Then I realized I mis-interpreted the front center jack point. Look at the attached picture. Instead of being where the green check mark is, I jacked up the car where the red X is. Could I have damaged anything? That piece felt very solid and didn't bend at all. Later after I realized the problem, I jacked the car up again using the correct jack point.
DSC05446b.JPG
Also, I didn't know where to put the jack stands, so I put them where the "A" arm is. See picture number 2. I figured that was the strongest point. Could I damage anything?
DSC05447.jpg
DSC05448.jpg
On one side, the jack actually hit the middle part instead of the bracket.

05-03-2010, 03:59 AM	#1 (permalink)
RedNismo Base Member Join Date: Jan 2010 Location: Glendale CA Posts: 92 Drives: 09 Nismo Z #389 RD Rep Power: 15	Oil Change Almost Failed Hi All, I just bought a low profile 2 ton jack from Harbor Freight so I could change my oil(my very 1st time). It turned out the low profile wasn't low enough for the Nismo front. So I had to use 2 stock jacks from different cars to jack each side up slightly to sneak in the 2 ton jack. Then I realized I mis-interpreted the front center jack point. Look at the attached picture. Instead of being where the green check mark is, I jacked up the car where the red X is. Could I have damaged anything? That piece felt very solid and didn't bend at all. Later after I realized the problem, I jacked the car up again using the correct jack point. DSC05446b.JPG Also, I didn't know where to put the jack stands, so I put them where the "A" arm is. See picture number 2. I figured that was the strongest point. Could I damage anything? DSC05447.jpg DSC05448.jpg On one side, the jack actually hit the middle part instead of the bracket. __________________ 2003 Skyline 350GT--Tein Suspension, NRG Strut bar, Nismo CAI w/bypass, JDM emblems, Nismo Graphics... 2009 Nismo Z34 #389-- Clear Bra Last edited by RedNismo; 05-03-2010 at 04:04 AM.