View Single Post
Old 04-04-2010, 12:39 PM   #38 (permalink)
kevr6
A True Z Fanatic
 
kevr6's Avatar
 
Join Date: Feb 2009
Location: N.W. Atlanta
Posts: 1,515
Drives: '09 Graphite 370Z 6M
Rep Power: 666
kevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond reputekevr6 has a reputation beyond repute
Send a message via AIM to kevr6
Post

Quote:
Originally Posted by azn370z View Post
Where did you get that blue sleeve to cover the springs? Did you use a spring compressor? I like how the rears are a little higher than the fronts.
Thanks
The springs come wrapped. I did use a spring compressor. The rears actually should sit a few millimeters higher but I left out the lower rubber pad that sits beneath the rear spring. I wanted it as low as possible!

Quote:
Originally Posted by ZForce View Post
Looks good, prolly even better than Eibachs. What is the spring rates? Any scraping over driveways with the front? I would say these drop the rear right into the sweet spot, not like the the Z33 where I hade to cut .5" off the rear rubber spring mount to get there.
I think that H&R does not release spring rates from what I've read elswhere on this forum. Actually there is less scraping/rubbing since the springs have less travel then the coilovers along w/ better dampening from the shocks/struts.

I put some pics on my profile album also!
Thanks guys!!
__________________
Beware...
Daily Sliding In My ZLED!

Last edited by kevr6; 04-04-2010 at 12:55 PM.
kevr6 is offline   Reply With Quote