Quote:
Originally Posted by TipsZ
Thank you both for your experience with this type of issue. I plan to get some pictures up in the next few days to show you guys what I am talking about. I too am worried as I purchased the GTM kit from Tardcore. However, the vendor replaced the suspect hose (with a much too long one at that). I need to confirm with Tardcore that he did not alter the lines, and that they were directly from the vendor .. that may give me a bit more piece of mind.
|
I think I would be concerned as well. Burst pressure on a correctly assembled Stainless socketed fitting is 1000psi. They shouldn't leak, and they shouldn't blow off. I suspect Tardcores's were pulled off due to no slack, but this may indicate a more serious problem with the hose assembly. If they are both leaking, both the old hose and the new, I would be doubly concerned. Until you can check them, I would keep my eyes glued to the oil pressure light. Correct assembly is outlined at the end of this .PDF:
http://97.74.103.94/files/bhose.pdf
These are re-usable fittings, so you may disassemble to check as mentioned above. It is critical that the hose goes all the way into the socket and is not pushed out when the nipple is tightened.