My final solution was a 4 inch height, 2.5 inch diameter, 600lb/ft spring from Eibach
We were able to trim the spring perch without machine work, it was thin enough metal we could take a centimeter or so off the top and that was enough to clear everything on compression
When planning your final height, the stance cup adds MORE than an inch. Their measurements said 30 mm or so but there's no way it was that. It's more like 1.5-2 inches since I had to go down from a 6 to 4 inch spring.
keep that in mind when thinking about where you wanna end up and your rear spring length/suspension parts planning
If you don't care about being stance-low, you will have an easier time than i did
|