View Single Post
Old 07-27-2022, 03:00 PM   #1 (permalink)
THE BULL
Base Member
 
Join Date: Apr 2021
Location: Florida
Posts: 217
Drives: G37S
Rep Power: 26848
THE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond reputeTHE BULL has a reputation beyond repute
Default ECUTEK/UPREV idle relearn

Hello everyone, is it possible to force an idle relearn on swaps?

Playing around with Ecutek on my swap I tried doing an idle relearn however it was unsuccessful. I idle around 750-800rpm/ 18% load after warm up(no codes) which is fine however it peeked my curiosity since Ecutek has the ability however some swaps wouldn't have IPDM, hood switch and other requirements "needed" for the relearn.

So far disconnecting/connecting throttles dont act like a Z/G where on some occasions requires the relearn, mine's coldstarts and goes through the warm up process just like OEM however stays at 750-800rpm instead of the 650-700rpm that usually see which doesnt bother me however makes me question if this is due to the lack of the learn which at the moment seems unobtainable.

Thanks in advance.
THE BULL is offline   Reply With Quote