Hey guys, sorry to thread jack. I’m having the same issues with S-mode; it isn’t working. Upon initial start up the S will be displayed in the cluster, then after driving a few seconds it throws the warning on the cluster screen. Codes I’m getting are P2765 input turbine speed sensor circuit B. I’ve changed the sensor on the trans on the left hand side and no avail. For reference, my Z is single turbo and triple disc clutch with cmak. S mode was working perfectly even after the build, and only recently have I run into this issue. I’ve checked the mentioned fuses, all good. I took it to Nissan today, and their scanners couldn’t connect to my Z. Unsure if tuning could be the culprit. Idk if it’s a CAN communication issue, nor do I know where the CAN-BUS wires/connector is located to assess it. I’ve checked all connectors going to the transmission and all is well there too. I’m open to any ideas or advice as I’m truly out of ideas and Nissan was of no help unfortunately.
|