Quote:
Originally Posted by Rojoryu
Well, I think I made a pretty stupid mistake. When I was turning the motor over by hand to time it, I didnt use the pulley or a spacer, I just put the bolt directly into the crankshaft. When I went to pull the bolt out after timing it I noticed it was a little tough coming out. And now it wants to bind up going back it after a few turns. I ordered a new bolt, but my fear is that I damaged the threads in the crankshaft. I assume I can chase the threads if that's the case but it's not something I have any experience with. Any suggestions?
|
Once you get the new bolt so you no longer need the old one you can clean the threads up on the old bolt and cut 2-4 slots lengthwise on the old bolt and use it as a thread chaser to clean up the crank.