Quote:
Originally Posted by Leingod
If yoy haven't, drop the black support brackets slightly. That'll help give yoy a spare inch or so of wiggle room.
|
Quote:
Originally Posted by Rusty
I dropped the tranny support bracket so the rear of the tranny drops down some.
|
Thanks guys, this is the tip I needed. After I dropped that bracket, I was able to get my 3/8" ratchet with a deep socket on that bolt.
Unfortunately now I have the exact same problem, with the switch itself. The only deep sockets I have that will fit it are 1/2" drive and won't fit up there with the wrench. I tried slipping the socket on and trying to grab it with vice grips, but couldn't get enough torque to break it loose.
I think these little adapters from HF will solve the problem, and something I never knew I needed until I just turned it up searching. I can imagine they will come in handy again the future.
https://www.harborfreight.com/3-piec...aps-67011.html