From the Rev 3.x instruction manual on RJM's website:
Quote:
|
* Note On Bleeding Clutch System* If you are attempting to manually bleed the hydraulic system (without a Power Bleeding System) while the RJM Pedal is installed then you must reduce the AFP setting to 0% restoring full stroke to the master cylinder in order toget all the air out. Failing to do so will make manual bleeding extremely difficult of not impossible. You must also adjust the Clutch Rod angle to ensure the master cylinder rod is moving straight in/out of the master cylinder after adjusting the AFP setting to Zero. Failure to adjust the clutch rod angle may cause binding of the pedal linkage and potentially damage to the master cylinder internally. Please see the Tuning Section of this RJM Installation Guide for Specific Steps Required.
|