Nissan 370Z Forum - View Single Post

zpwrgirl · 03-31-2021, 12:45 PM

Hey all!

So, after my fiasco with my gauge needle, I considered doing something a bit different. I'm wanting to change out the tach, speedo and fuel gauge with aftermarket, properly sized versions of themselves. I was told, for the most part, the change would be plug and play. However, I'm going to lose my indicators that are present on the tach. This leads to a question. Is there a way to direct the indicator signals to an outside source or to a separate monitor so I can keep track of them easier, should an issue arise? If not, I could always use an obd2 reader at all times, but I'd prefer a cleaner approach.

Any insight into this would be great, especially if you or someone you know has done similar.

Thanks!

03-31-2021, 12:45 PM	#1 (permalink)
zpwrgirl Base Member Join Date: Feb 2020 Location: Ohio Posts: 28 Drives: 19 370z Black Manual Rep Power: 5	custom gauges Hey all! So, after my fiasco with my gauge needle, I considered doing something a bit different. I'm wanting to change out the tach, speedo and fuel gauge with aftermarket, properly sized versions of themselves. I was told, for the most part, the change would be plug and play. However, I'm going to lose my indicators that are present on the tach. This leads to a question. Is there a way to direct the indicator signals to an outside source or to a separate monitor so I can keep track of them easier, should an issue arise? If not, I could always use an obd2 reader at all times, but I'd prefer a cleaner approach. Any insight into this would be great, especially if you or someone you know has done similar. Thanks!