Anyone measure bump & droop when installing coilovers? Roll Center?
Here are some pics of my bump(full compression, no springs) and droop (full decompression).
Rear full droop:
Rear full bump:
Rear Ride height:
Front full droop:
Front full bump:
Front Ride height:
Measurements: (from the top of the center cap to the center-most part of the fender)
Rear:
Fully Compressed (no spring): 317.5 mm
Full droop: 444.5 mm
Ride height (car on ground with spring): 352.425mm
Front:
Fully Compressed (no spring): 311.15 mm
Full Droop: 444.5 mm
Ride Height: 342.9mm
I may raise the front a bit, looks like I'll need a swift spring to properly preload the fronts, If I go any higher, the springs become loose. Only way to tell is to do a corner balance which will hopefully happen after I get my half-cage done.