Nissan 370Z Forum - View Single Post - Foam Absorber Not Fitting with Nismo 15+ Front Bumper Conversion

HungryHuebert · 08-11-2020, 07:07 PM

Hello all!

I hope everyone is doing well out there! I just installed my Nismo 2015+ front bumper on my 2011 370Z! However, I had to remove the polystyrene foam absorber in order to make it fit properly.

Has anyone else run into this issue or found a workaround to this? Any help and support would be much appreciated!

I would prefer to have the foam absorber in there so that the crumple zones can work as intended for front-end collisions. I'm also a tad bit concerned that it'll expose my cold air intake to water during wet seasons.

Cheers!
H

08-11-2020, 07:07 PM	#1 (permalink)
HungryHuebert Base Member Join Date: Aug 2017 Location: Austin, TX Posts: 1 Drives: 2011 Nissan 370z Rep Power: 8	Foam Absorber Not Fitting with Nismo 15+ Front Bumper Conversion Hello all! I hope everyone is doing well out there! I just installed my Nismo 2015+ front bumper on my 2011 370Z! However, I had to remove the polystyrene foam absorber in order to make it fit properly. Has anyone else run into this issue or found a workaround to this? Any help and support would be much appreciated! I would prefer to have the foam absorber in there so that the crumple zones can work as intended for front-end collisions. I'm also a tad bit concerned that it'll expose my cold air intake to water during wet seasons. Cheers! H