Sorry guys I haven't been keeping up with this site. But yeah after I put the 3d printed intake on the car the thing loved it! Last winter it was nuts driving it with cold dense air being at 5000ft elevation.
This is a youtube video I uploaded back in January
https://youtu.be/6YVHLzsSg4A
when I started taking the supercharger off because the compressor impeller came loose and was rubbing against the side walls. Then covid hit and I pretty much left it alone. Unfortunately I am not going to be able to fix the supercharger until later this year or summer time next year. So I will not be able to give you guys any boost numbers or power numbers for a while.
Chopping as much support as I did out of the front of the car actually makes the hood a little loose at high speeds because the hood pin is flopping around on a cantilevered piece of metal, so I am going to weld some support in around that area so my hood does not fly open! Other than that the radiator is fine