Quote:
Originally Posted by thekinn
The issue with that is the other pad material left on the rotor when you switch. I've had issues where my pads and rotors kind of looked like the OPs (not quite that bad) when switching from street to race without a clean rotor.
One way to clean the street pad off is to just run the race pads on the street.. it basically acts like a lathe when cold and will do a pretty good job after a 100 or so miles of street driving. Then you are ready to bed in the race pads for optimal performance.
|
Sorry to hi-jack, but if tracking on XP10 and occasional street driving, does the cold temp lathe effect remove that initial transfer layer? I guess what I've been wondering is whether I need to re-bed the pads after stints of short street driving and before track days? Thanks!