Quote:
Originally Posted by TheFLiP
How did you end up wiring the LED for the switch? I get that I can just use the Normally Closed and Common leads on the switch and it will work without the LED halo.
I'm just cautious to fry the yaw sensor by introducing a current improperly. Thanks!
 |
Just saw this, here's how to wire it
Plug wires:
Black- Ground (there is a black ground wire going to the sensor, but could just be attached to chassis ground)
Green wire- 12 volt side of green sensor wire.
Red/Blue- Twist together but don't attach to anything.
Yellow- Other side of green sensor wire (sensor itself).