Quote:
Originally Posted by jchammond
Remember, the housing is not perfectly squared up- as the way it’s welded around it.
I used a large socket on one end, a through bolt as big as would fit & pulled them in place.
Be sure to do as Rusty says & clean hole good with flapper wheel or something, as they have a glue/epoxy residue on them
|
Yeah. Even the SPL install instructions say to expect some aluminum to shave off due to the oval hole. Got a dremel at the ready.
Quote:
Originally Posted by jchammond
Use a fine thread hardened threaded rod, as big as the hole in bushing 
They can still be very snug going in the hole 
 |
Think something like this would do?