Thread: The New “What did you do with your Z today” (with off topic replies) XXXVI
View Single Post
Old 04-14-2020, 10:49 AM   #1210 (permalink)
vtec to vvel
A True Z Fanatic
 
vtec to vvel's Avatar
 
Join Date: Feb 2015
Location: 813
Posts: 3,915
Drives: 13 Z
Rep Power: 502909
vtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond reputevtec to vvel has a reputation beyond repute
Default
Quote:
Originally Posted by jchammond View Post
Gonna run OSB vertical on rooftop; so had to install a board beside ridge board w/0.75”gap on each side.
Then installed blocks between purlins at 48” center from 2nd post; I staggered them so I could screw directly into each end, then scabbed the other 2x beside it & toescrewed it on both ends.
Leaving a 3” wide area for where plywood will meet
Only got 4/more sections to do this way & then it’s plywood time.





Btw, so breezy yesterday; blew my 12’ ladder over


Sent from my iPad using Tapatalk
You do all this yourself? If so, you got serious talent! Quite the architect/carpenter.
__________________
Don't like what I post? Too bad. I really don't give a sh!t
vtec to vvel is offline