August 2019:
Found some time to install the oil cooler, filter relocation, and lines.
Trying to finish mocking up the piping.
September 2019:
The A/C lines are such a PITA - continually ordering/swapping the A/C lines. Went through about 4 or 5 lines until shelving the headache until there was more time to tackle the issue..
November 2019:
Installed RJM Tilton Master Cylinder and started hooking up vacuum lines.
Still scratching the head about this damn A/C line..
Starting to look like a car again though!
December 2019:
Finally powered through the A/C line and finished the piping.. Only to take it all off again.
January 2020:
Got the intercooler pipes back from powder, reinstalled it all, started on the tidbits that are left - boost controller, grounds, engine mounts, etc.
Pretty much as "finished" as it'll look.
Version 2.0 (Updated):
Fast Intentions Twin Turbo Kit
Stage 3 - Xona Rotor 65.64 (HTZ-3579) Turbos
TiAL MV-S Wastegate Springs 14.5psi/1bar (Black/Red)
RJ Manufacturing Closed Deck Block
Carillo VQ37 H Beam Rods w/CARR bolts
Traum Pistons Custom Billet 10:1 cr
VQ37 Crankshaft
CJM Twin Pump 255/450
CJM VQ37 Fuel Rails
ID1700x Injectors
Tomei ProCam 272 duration 10.8 lift Intake & Exhaust Cams
Ferrea Competition Plus Valves
Ferrea Dual Valve Springs
Ferrea Locks
Ferrea Spring Seat Locators
Ferrea Titanium Retainers
Dynosty Head Gaskets
ARP 625+ Head Studs
SuckerPunch Motorsports Billet HR/VHR Oil Pump
ATI Super Damper
EPS Oil Gallery Gaskets
Solid Motor Mounts
Synolimit Ported VQ37 Upper/Lower Intake Manifold
Synolimit Ported Throttle Bodies
AdminTuning Combo Tank
RJM Tilton Master Cylinder
Uprev GT MAFs
Clutchmasters FX850 Twin Disc
Gram Lights 57xtreme 275/35/18x9.5 +22f and 295/40/18x10.5 +40r
Soon (ish?) 2020:
Rework the downpipes, add fluids, and finally
START??
