View Single Post
Old 12-20-2019, 06:40 PM   #169 (permalink)
gbrettin
A True Z Fanatic
 
gbrettin's Avatar
 
Join Date: Oct 2010
Location: Portage, MI
Posts: 2,284
Drives: Tricycle
Rep Power: 589151
gbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond reputegbrettin has a reputation beyond repute
Default

Quote:
Originally Posted by Rusty View Post
To make them thick enough for the stress. You would be spacing the bearings out too far. Then you will end up with alignment problems between the rotor and caliper. Pushing the rotor to the outside. The rotor would no longer be centered in the caliper.
I'll be sure to give it a good one over; but, the plate mounts completely flat and shouldn't be zero stress. Again, I'll look it over real good before anything happens. Thanks for the heads up.
gbrettin is offline   Reply With Quote