Nissan 370Z Forum - View Single Post

20IOZ · 10-30-2019, 04:14 AM

Decided to give the titanium intakes a go. Happy with the initial fitment, but needed to make a couple of small adjustments:

- trimmed a mm or two off the corner of one of the brackets to clear a bolt and improve fitment
- added an o-ring to the MAF sensors to ensure an airtight seal (the threaded section is slightly raised so there's not quite enough compression of the factory MAF sensor gaskets)
- will likely swap the throttle joiners for wider ones to increase overlap with the throttle body and pipe

Next job is to fabricate the air boxes. Working on the moulds at the moment, looking to draw air through the bumper and from behind the wheel liners with the rest of the box sealed against the bodywork to prevent engine bay air entering. May also add an air feed from the fang area of the front bumper, but undecided at this stage.