I just replaced my AEM 370Z Electronically Tuned Intake System with another new cold air intake system.
One of the MAF sensors went bad and when I tried to pull them to test which one was going out, I stripped one of the bolts holding in the MAF. funny thing is that MAF, on the passenger side, was fine. So, I JB welded the bolt back on the passenger side with the good MAF and reinstalled it. So, I decided just to buy two new MAFs and get a new cold air intake that put the air intakes out in front like the Stillen Gen3.
So, what you see is what you get. The two AEM cold air intake pipes both with the MAFs still attached. The passenger side is fine but cold welded on, the driver’s side still works but keeps throwing up high temps on the ECU. That being said the MAF on the driver’s side should be replaced.
You would have to relocate the windshield washer reservoir on the passengers side though to install these if I'm correct.
Local sale only unless buyer pays for shipping, asking $200 or best reasonable offer.
AEM intakes.jpg
JB weld on MAF bolt.jpg