View Single Post
Old 07-21-2019, 05:19 PM   #8 (permalink)
obender66
Base Member
 
Join Date: Jun 2015
Location: Toronto
Posts: 69
Drives: 2016 370Z Base 6M GM
Rep Power: 10
obender66 is on a distinguished road
Default

Update:
Took the bleeder out-nothing. Just stuck a pin in hole where bleeder came out and all the goo started to drip-dark gray, almost black, gradually getting cleaner. I let it gravity bleed for about 5 minutes, then I screwed back the bleeder and hooked up Mityvac vacuum pump(8500 model) and let it drain overflow tank about 3 times. No, it does not have enough pressure to damage the seals, but does great job evacuating the old fluid out. I do not think that fittings can properly seal the system to get the air out, if any-that was not my issue.
Tightened bleeder up, started the car-all gears worked fine. So Mityvac as one person fluid replacement device works.
For a little piece of mind I did clutch pump routine couple of times-all clean liquid coming out, all gears work fine.

Thank you all for help

Alex
__________________
2016 370Z Base/Setrab/AEM/Uprev/M7 Japan/Magnaflow/Quaife/Wilwood/300 whp
2003 G35 sedan 6MT(good bye-after 15 years together )
obender66 is offline   Reply With Quote