I have an adapter for an oil pressure gauge sensor in the stock oil pressure port. Was always uncomfortable with the finger-breadth of clearance between the sensor at the end of the adapter and the sway bar. If I recall correctly, the sway bar, when the Z is on jacks, will be right where the metal braid begins on the side of your line that goes into the OEM port. Just by eyeballing it, I'd be concerned about clearance with the distribution block too. If I get the Z up on the QJ this weekend I'll try and get measurements from the sway bar to the bottom edge of the upper oil pan for you.
__________________
'14 MB Nismo | Boost Lab 6870 1.32 AR 553 HP / 471 ft.-lbs.
Betty Mods
|