Off Motordyne's website:
On the driver side floor panel heat shield there is a M6 stud that protrudes down about 1”. This stud will create an interference fit. Trim the stud flush down to the panel to allow for ART pipe clearance. Install all the bolts for the ART pipes only finger tight, then adjust rotation/alignments as needed, then tighten all the bolts working from front to back starting at the inlet to the brace to the outlet
__________________
Fast Intentions "Stage Seb" twin turbo #098- Specialty Z/Tial-Xonarotor/CJM/Ecutek/HKS/KW/SPL/Hotchkis/Rohana/Toyo
700+whp
|