Quote:
Originally Posted by -ZS-Carpenter
It's almost like you didn't read the thread at all.
As I said above a few days ago, going with Z1 14lb flywheel.
Other than guessing that moving to a cmak will cause issues just because, can you point to any thread where people are having problems with the V3.x cmaks. Any actual instances of recurring issues? I have seen nothing but praise since the V2 was released. If I missed something post some links, until then it's either hearsay or conjecture.
And I'll say it again. The trans won't go back in the car with the hydraulics inside the bell housing. I don't care how great the HDCSC might be. If it fails the trans has to come out and there is a good chance it will ruin the clutch disk when it sprays brake fluid inside the bell housing when it goes. Until I smoke this clutch the trans is staying in the car.
Sent from my SM-G965U using Tapatalk
|
Call Z Speed, they literally make BOTH of them and did testing on both of them. It was the Owner of L Spec in California that talked about the CMAK issues and Z Speed recommending the HD CSC over the CMAK when I was planning on getting the CMAK. That was a while ago and so I don't have links for you except those two companies