Quote:
Originally Posted by Rusty
Position carefully. I got mine up a little too high on the fender. I'm about 1 1/2" down from the top roll of the fender. Maybe should have been down about 2 1/2 ". Everything fits flush but the bottom curve of the vent. Have about 1/4"gap that I have to play with. And cut the outside edge of the temp plate. Even doing that. I still had to made the hole bigger to get the vent into the hole.
Do you have the temp plates?
|
I was looking at Derrago's(sp?) install and it looks like he may be a bit higher up maybe ~1" from the top.
I am going to go to the garage and look at it now.
