View Single Post
Old 10-13-2018, 12:31 PM   #2543 (permalink)
cupcakez
Track Member
 
Join Date: Oct 2017
Location: California
Posts: 635
Drives: 2009-7AT-Base-Coup
Rep Power: 4836
cupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond reputecupcakez has a reputation beyond repute
Default

Quote:
Originally Posted by TopgunZ View Post
He won't need to drop the bumper for a flex fuel setup.

Cupckakes...remove that hood latch support. It is fine without it. The couple will fit better then.

Also, spray Windex in every coupler before you put them on. They will slide into place a thousand times easier.

Do not tighten any clamps at all until all the couplers are where they should be or you might create a fitment issue.

Totally didnt think of using any type of lubrication.
Going to try that
And also take off the black support bar behind the coupler on the top left of the intercooler (passenger side) so the coupler wont be so extremely tight as it is now.

Thanks! Also PMd you regarding some part numbers if you wouldnt mind sharing that ):
I had to replace my air filter since it was caked with dirt from the accident.

Now a few other parts too
__________________
|| ECUTEK (Eugene) || A2A || IPP Built Motor Stage IV Spec || RJM Short Block || Quaife LSD || KW V3 || Stillen-Exhaust || 11.0.1 CR || 928 Full Rebuild || CPZ 34 Row Oil Cooler ||
cupcakez is offline   Reply With Quote