Quote:
Originally Posted by JLarson
That is my entire job. One of our fabricators came in yesterday with questions about part marking location on a newly finished assembly. Turns out the reason she couldn't figure out the drawing view was that the welder welded a flange on backwards... Reject!
|
You should do QC on piping at a power plant during construction.
I found control valves and check valves installed and welded in backwards. And this was after the welds was heat treated.
I wasn't QC there. I was just walking down the different systems and learning where everything was at and the flow paths. It was part of my training to operate the plant.