Quote:
Originally Posted by mlsully
I bought a used switch that had the harness still attached, but the wires were cut off. 2 wires go to a switched power source for the light on the switch. I tapped into another harness under the center console for this. So when I turn on my head lights, the switch lights up like the factory one would. The other two pins are for the release itself. Just ground one and then run a wire to the BCM. If it’s not under the panel on the right side of the car, check the left.
The bottom harness in the pic is what you’re looking for under your kick panels.
|
That makes sense - I had overlooked the switch illumination.
I would really like to source a plug, I am hoping its a JST but I don't know the size. It might become clearer when the switch arrives.
When I was younger you could wander round car scrapyards removing parts you want but these days with health & safety in the UK you cannot do this any more in case a car falls on you.