View Single Post
Old 07-05-2018, 12:50 PM   #6 (permalink)
DarkJak
A True Z Fanatic
 
DarkJak's Avatar
 
Join Date: Jun 2011
Location: Madison, WI
Posts: 1,397
Drives: 2009 370Z
Rep Power: 16804
DarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond reputeDarkJak has a reputation beyond repute
Default

Quote:
Originally Posted by Rusty View Post
If making your own. Use the red high temp hose. It doesn't crush as easy. You can buy the flanges for the backing plates online, and mod the stock plates. For the inlet ducts. Lots of different styles online.

The Stillen kit uses a 2" red hose. Which is fine unless you are a heavy braker at a advanced level. Then you have to go to a 3" or 4" hose. Then the problem starts. Trying to route the hose around.
Yup, the 2" was just barely able to squeeze in for routing, but I see 3" being needed pretty easily. And there's no way that would fit through the existing path for the 2"/
__________________
@stupidtoycars | My track vids
09 7AT|MCS 2WNR|Topgunz Rotrex|Ecutek (Eugene)|Maxxis RC1|Titan-7 TS-5|OSG LSD|Rear Mount Derale Oil Cooler (WIP)+25 Trans Cooler|Fismo|G-LOC R12/R10|Zeta III L|NLR Wing and Splitter|CJM Pan and Fuel Hat|Radium Surge Tank|AP Racing CP9668
DarkJak is offline   Reply With Quote