Quote:
Originally Posted by JLarson
Sweet merciful crap. 12 hours later... Clutch in. Flywheel in. New CSC in. Ready to re assemble, can't get the splines aligned. Like an idiot i re attached some of the wire harness already. Have to disconnect it and move trans back out to check spline orientation.
|
I leave the tranny in gear when I remove it. When installing it, and the splines don't line up. I turn the output shaft a little to turn the input shaft. And when the tranny pops in. Unless the disk and pilot bearing are not align up. Then you have to use the alignment tool again.