Sort of bringing this thread back from the dead. I just installed my brace and had a similar issue of only being able to get two of the three bolts in, but for me I got the upper and lower ones. The middle bolt didn’t seem to quite line up properly, there are marks on my brace from the screw grinding on it as it tried to thread so I bailed on that middle bolt.
As far as the main bolt and jam nut, do you guys think more or less finger tight is okay? I only had access to a normal length 19mm wrench, I snugged the bolt as best I could by hand against the master cylinder, and was only able to maybe get a quarter turn with the wrench on the jam nut after finger tightening it before the angles didn’t allow me to go any further with the wrench. Want to see what you all think.
|