Nissan 370Z Forum - View Single Post

Asus_ · 04-25-2018, 08:34 PM

I tried calling KW again, spoke to another rep and this is the info i got, It's possible to put linear springs but i need to buy the following . . .

- springs inner diameter is 61mm
- apparently i need to to buy tophats?
- they say i dont have to change the back springs since i only DD not track.

Is all this accurate? I'm going to give Swift a call tomorrow, do you guys have any affordable recommendation of a good spring, i honestly trust this community's opinion, you guys know more about this than i do.

Side Note: heard a loud clunk today wen turning the wheel to one side. it was hard to turn.. The car was off but push start was in "on" position. should i be worried?

04-25-2018, 08:34 PM	#3 (permalink)
Asus_ Enthusiast Member Join Date: Sep 2015 Location: neverland. Posts: 348 Drives: 2011 370z T/S Rep Power: 1171	I tried calling KW again, spoke to another rep and this is the info i got, It's possible to put linear springs but i need to buy the following . . . - springs inner diameter is 61mm - apparently i need to to buy tophats? - they say i dont have to change the back springs since i only DD not track. Is all this accurate? I'm going to give Swift a call tomorrow, do you guys have any affordable recommendation of a good spring, i honestly trust this community's opinion, you guys know more about this than i do. Side Note: heard a loud clunk today wen turning the wheel to one side. it was hard to turn.. The car was off but push start was in "on" position. should i be worried? Last edited by Asus_; 04-26-2018 at 04:28 AM.